DIRECT CONNECT MANUAL :: essays research papers

How use take up Connect behind a firewall/router in Active Mode instead of Passive1.Determine your WAN IP address and your LAN IP address this can be make either by using winipcfg.exe or ipconfig.exe in my case aspect on the status page of my Linksys router configuration.2.Now set up DC by going to settings connection and marking the block use Direct Connect in Active Mode, In the force DC to comport connections on this port I have 412 (Im not indisputable if this matters entirely it has worked for me) you may want to play around with it a minute but I believe it has to be a port amid 375-425 because these are the ports Direct Connect has to have open to function in Active Mode.3.Check the block force direct connect to account this IP and put in the WAN IP address obtained for your fact in Step 1. This completes the setup of DC.This will vary slightly for soul Situations I will explain it for a linksys cable/dsl router but the same should apply regardless of what your usi ng for a firewall.1.On the linksys router go to the advanced/ beforeing tab in the service port value boxes on the left in the first one put 375 and in the second put 425 this will open this range of ports on your router and forward them from the WAN side of your Firewall to the LAN side (the same probably applies to whatsoever you are using for a Hardware/Software Firewall solution these ports invite to pass from the internet side of your Firewall to the intranet side of your Firewall. 2.Now in the next block (at least on the linksys you need to select forward two I tried just udp and just tcp individually it didnt seem to work correctly until I selected forward both.3.In the IP address box this is where you will want to fill in the prop to forward the ports to at least on the linksys you can do this by individual IP address. Put the IP Address of the machine on your LAN that you are using Direct Connect on. If your are streamlet DC on multiple machines you may have to repea t travel 1-3 for each IP on your LAN running DC. Click implement restart DC and you should now be able to use DC and search multiple hubs behind your route/firewall without any problems.